![]() Config sys virtual-switch Create the interfaces that you want, including the physical ports you want for each. ![]() Which causes performance issues under load.įor the situations where I've wanted to use VLANs directly on the FGT, I've used the virtual switch functionality. Using a software switch prevents any functionality from being offloaded to the ASIC chips in your Fortigate. Is there a 'right way' to make fortigate 100d 'vlan friendly'? Do yourself a favor and avoid the software switch functionality if at all possible. But, doing this forces to use a different subnet than the one i want since i have to give the software hardware switch an ip address. (e.g port 10 will have vlan tag 10 and port 12 will have vlan tag 12) all i see is an option to create software hardware switches, assign interfaces into them and then create vlans. I am trying to create a situation where different ports interfaces will have different vlan tags. After resetting to factory settings, the unit defaults to 1 hardware swtich without any vlan tagging. Hi Guys i am trying to configure a fortigate 100d unit.
0 Comments
Leave a Reply. |